The sliding table serves for the clamping of individual modul parts
during their final polishing.
The part is clamped onto a circular turnable
table with T-slot and clamps. The table can be placed in three
different positions (it can be turned, tilted and adjusted at various
heights). The abrasive residues can be rinsed away of the polished
parts by means of pump with a separate water supply - the
filter-back-wash outlet leads into a sump.
The construction of the table consists of a supporting column weldment which is
connected to the weldment of a holder placed at the turnable table. The frame
which is made of steel tubes is situated behind the table and serves as a
protective element. This framecan also be used as a holder of accessories, i.e.
side-pallet, tool chest, pump with a water tank, vessel for waste rinsing water,
electric switchboard etc.
We can fit out the table with such an additional equipment that
enables to check the polished surface. This additional outfit includes
especially a halogen lamp, magnifer with na independent lighting and a
light source with a light-cabel for a suffiencent illumination of places
with a difficult access.
carrying capacity of the work table
maximum ground plan of the clampsed parts
305 x 305 mm
range of table turning
range of table tilting
min. height 800 mm
max. height 1040 mm
dimensions (length x width x height)
1500 x 1200 x 1200 mm
mass (according to accessories)
150 - 200 kg
220 V, 50 Hz
- work halogen lamp
- magnifer with separate lighting
- light source with a light cabel for the check of places with difficult access
The constructio of this table can modified in compliance with he concrete requirements of our